Unscrew any remaining screws on the front panel.

Release the tension from the spring holding the seal in place.

Use needle-nose pliers to pull the seal up and locate the spring.

Open up the washer door and remove the seal around it.

Remove the screws holding the control console.Unscrew the top panel to gain access to the front panel.On a front-load washer, most models require removal of the front panel to access the drain pump, internal hoses, and sump filter. Most Electrolux washers are front-loaders. The next parts of the washer that need to be checked require opening up the washer. Check the lid switch wires to make sure they are connected.If there is no continuity, replace the lid switch with a new one.The door needs to be closed to get an accurate reading. Access the lid switch by removing the necessary panels.On other models, a panel on the lid will need to be unscrewed, or the top panel will need to be removed to access the switch. If you can see the switch, you can test it by pushing a pencil against it to see if it allows the washer to drain. When you open and close the lid, you may be able to hear if the lid switch is working or not. Top-load washing machines will not drain if there is a faulty lid switch. Put the pump guard filter and emergency hose back into the machine.Rotating it should release any debris that is stuck. With the filter out, check the pump impeller.Wash the filter in the sink to clean it.Place the hose in a container and remove its cap.You will also need a container to collect the water that comes out. Before unscrewing the filter, make sure to put a towel down. You should be able to open the panel with your fingers or a flathead screwdriver. It is usually located behind a small panel at the bottom right of the machine.

Some Electrolux models feature a drain pump filter. Hot water a mixture of water, vinegar, and baking soda or a drain snake can be used to clean it. You may need to remove the rear washing machine panel to access the hose. Disconnect the hose from the washing machine and wall.Sometimes grime can build up and cause a hose blockage. You can also feel the hose to see if it has become blocked. If the hose is bent or twisted, straighten out the hose so that water can flow through it. The first thing you should check is the exterior hose coming out of the washing machine. This guide applies to the following models: Make sure to disconnect the washer from the power and turn off the water to the washer before proceeding. Fortunately, by following this guide, you should be able to easily resolve the issue. If your Electrolux washer has stopped draining, the most likely cause is a blockage somewhere within the machine. Electrolux makes a range of great washing machines designed to last even with heavy usage.

Electrolux time manager problems